ATEX / IECEx Genel Bakış

Ex-proof ekipman tasarımının teknik temeli: patlayıcı atmosferlerin nasıl oluştuğu, bölgelere nasıl sınıflandırıldığı ve uluslararası standartlara göre ekipmanların nasıl işaretlendiği.

General Teknik Bilgiler

An explosive atmosphere is defined as a mixture of dangerous substances with air, under atmospheric conditions, in the form of gases, vapours, mist or dust — in which, after ignition has occurred, combustion spreads to the entire unburned mixture.

The three requirements for an explosion:

  1. Flammable gas, vapor or dust within certain limits of concentration
  2. Air containing a minimum concentration of oxygen
  3. An ignition source of minimum temperature and energy
🔥 OXYGEN HEAT FUEL FIRE TRIANGLE
Flammable gasses require only small amounts of energy to react with atmospheric oxygen, such as a spark or hot surface. Therefore, the surface temperature of mechanical and electrical equipment used is also of importance.
Flammable sıvılar change into vapour phase that forms a potentially explosive atmosphere near their surface. Depending on the properties of each liquid, the proportion that has evaporated into the surrounding air is determined by the temperature of the liquid.
Flammable solids in the form of dust, fibre or flyings can react with atmospheric oxygen and produce significant explosions. Toz layers begin smouldering on hot surfaces, while a dust cloud can explode immediately through contact with a hot surface or by an ignition source.

Temperature Classifications

Protective methods have been developed and defined in standards and regulations around the world to prevent loss of life, serious injuries and significant damage that explosions can cause.

Turkey Regulation

In Turkey, "The Regulation on Equipment and Protective Systems to be Used in Potentially Explosive Environments (94/4/AT)" issued on 30.12.2006 via No. 26392 (4. rev) is in effect. This regulation is in parallel to the European Union Directive 94/9/EC.

EU Directive (ATEX 95)

Directive 94/9/EC — also known as "ATEX 95" or the "ATEX Equipment Directive" — concerns the approximation of the laws of Member States on equipment and protective systems intended for use in potentially explosive atmospheres.

The two widely used ways of reducing the risk of explosion are preventing release of dangerous substances to avoid creation of explosive atmospheres, and in potentially explosive atmospheres, preventing sources of ignition by using Ex-Proof Equipment.

Bölge Classification

Probability of a potential explosive atmosphere occurring, mapped to equipment group, category, explosion group and Ekipman Koruma Seviyesi (EPL).

Bölge Probability of a Potential Patlayıcı Atmosfer Occurring
Gaz Toz
0 20 Always, temporarily or often present.
1 21 Occasionally present.
2 22 Very seldom or only for a short period.
Ekipman Grubu Ekipman Kategorisi Patlama Grubu EPL Bölges
I M1 I Ma NA
M2 Mb
III 1G II A Ga 0
2G II B Gb 1
3G II C Gc 2
1D Da 20
2D Db 21
3D Dc 22

Ex-Proof Ekipman İşaretlemesi

Bir ATEX / IECEx ekipman işaretleme dizisinin teknik dökümü — her segmentin ne anlama geldiği ve gaz ile toz ortamları için nasıl okunacağı.

Bu, ATEX / IECEx standartlarına dayalı Ex-Proof (Ex) Ekipman İşaretlemesini açıklayan teknik bir şemadır.

Gaz
ATEX / IECEx equipment marking diagram for gas and dust environments Ekipman Koruma Seviyesi (EPL) Sıcaklık Sınıfı Patlama Grubu Koruma Türü Patlama İşareti Patlayıcı Atmosfer Suitability (G-Gaz) Ekipman Kategorisi Ekipman Grubu Patlama Koruması İşareti Ex II 2 G Ex d IIC T6 Gb II 2 D Ex t IIIC T80°C Db IP 6 5 Ekipman Grubu Ekipman Kategorisi Patlayıcı Atmosfer Suitability (G-Gaz) Patlama İşareti Koruma Türü Patlama Grubu Sıcaklık Sınıfı Ekipman Koruma Seviyesi (EPL) Giriş Koruma Sınıfı Koruma Karşı Katı Cisimler and Toz Koruma karşı sıvılar
Toz

Not sure which zone or marking applies to your site?

Send us your application details and our engineers will specify the right ATEX configuration for your environment.